Nynette Flooring August 13th, 2017 - 19:30:59
The manufactured joist, which is a relatively new product, is often manufactured from low cost materials in the shape of an I beam, similar to steel beams in larger buildings. What this means is that the joist is constructed with a thicker top and bottom edge, and generally interlocking aspenite vertically spanning between the two. These systems are very strong, often capable of spanning the entire width of the building.
Dust, grit and moisture are gifts of nature and we all have to deal with them. Grit which stems from sand or dirt being tracked from the outdoors on the surface works like sandpaper on the floor finish. Dust mites, balls and the like are merely pulverized bits of dirt which in essence acts in the same way as grit over the long haul on your floors. Once your floor finish gets damaged grit and dust left on the surface tend to discolor the hardwood while being ground into the surface pores with each step made on top of it like a hammer pounding stroke after stroke.
Seventh, are you a do-it-yourselfer? Think through every step of the process to be sure that you can do it yourself. Usually the install can be done with relatively moderate skills and simple tools like a chop saw and rented flooring nailer. The finishing process is a whole different matter. The sanders and buffers take some special skills to operate. A normal price range for labor and materials to install a wood floor is $4-5 per square foot. It is possible to build your own sweat equity into a floor install. Maybe this is where you choose to use our engineered product for example because it is presanded to more accurate tolerances than a solid wood product. It can be touched up with a hand held orbital sander rather than industrial floor sanders. Then if you are doing the finish yourself, you will want to consider using a finish that may not require as much buffing between coats.
We personally do not care for prefinished flooring due to installation problems associated with it, so our product requires site applied finish. This means that your floor finish if site applied will be easier to sand and refinish than a prefinished floor. Also you do not have to deal with that micro bevel groove between each board that tends to fill up with dust and crumbs. Most prefinished hardwood floors really can`t be refinished easily. To sand it off means that the wear layer has to be thicker than the height of the nails and have room to sand off the micro bevel between boards; that amounts to a lot of sanding. You also will not be able to spot sand or touch up parts of the floor.