Published at Tuesday, July 18th 2017. by Solaina in Flooring.
Traditional tile installation requires many tools and lots of patience which have to be pre-set on the floor, cut down to size, then adhered to the floor using a strong industrial glue. They will not stick to every surface and frequently, a layer of floor base must be installed before the tiling work can begin. If the tiles are placed too close together, they can buckle, leaving unsightly bumps and lumps on the floor. If they are placed too far apart, there will be obvious gaps. If a mistake is made when laying down the tile, it is very difficult to fix as the tile is glued to the floor. The tile will have to be pried up, excess adhesive scraped, and the process started over. Laying traditional tile floors is a project that can take several days, to several weeks, to finish.
Another good flooring for wet areas is the vinyl tile. Typically it is manufactured in much the same way as sheet vinyl, but is much more rigid and comes as 12"x12" square units. They are installed in the much the same way, but require skilled tradesmen, familiar with proper installation. A good installer will start from the middle of the room to ensure that all cut tiles are equal in width at opposing walls. One advantage to this type of flooring, over sheet vinyl, is that it is can be installed, without danger of joint separation, over large areas. For this reason, it is often used in commercial buildings where large rooms are the norm. Vinyl tile can also be easily installed directly to concrete floors. Like vinyl sheets, it too is resistant to water, and tends to be installed in the areas of a building, prone to water accumulations. Tile, can be easily cleaned, is relatively maintenance free, and one of the cheaper finished floors to install.
Traditional floor tiles can be difficult to replace as well. If one tile is damaged, in most cases all the tiles around it have to be replaced in the repair process. This is a costly and time consuming procedure. If one of the interlocking floor tiles is damaged, it is easy to pull the damaged tile up and replace it quickly. The repair time on broken interlocking tiles would take seconds, as opposed to the hours it would take to replace traditional tiles.
Moisture is definitely a no-no when it comes to your hardwood floor. Even though you know that trees are grown from a major ingredient of water, you also know that water aids wood in changing its shape. Just for kicks, ask yourself this question: Would you wash down your intricately etched wood and antique finished dresser, curio or bedroom suit with any type of water solution? Your wooden floor needs that same type of care and attention in order to yield many years of comforting wood floor sheen, elegance and beauty.
Undoubtedly you`ve seen wood floors where it seems that the edges or seams of boards joined together curl up or the width of a board creates a bow like upward arc in the middle. These are indications of moisture damage to a wooden floor. For example, there have even been instances where moisture damage caused floor boards to arc together to raise a full length sofa about three feet into the air. That was merely from the curl effect and strength of water on wooden floor boards. So, by all means do dry any spills to keep moisture and liquids away from your wooden floors.
We personally do not care for prefinished flooring due to installation problems associated with it, so our product requires site applied finish. This means that your floor finish if site applied will be easier to sand and refinish than a prefinished floor. Also you do not have to deal with that micro bevel groove between each board that tends to fill up with dust and crumbs. Most prefinished hardwood floors really can`t be refinished easily. To sand it off means that the wear layer has to be thicker than the height of the nails and have room to sand off the micro bevel between boards; that amounts to a lot of sanding. You also will not be able to spot sand or touch up parts of the floor.