Calantha Flooring August 02nd, 2017 - 18:02:10
All joists must extend at least 1-1/2" on to a bearing assembly, of either a beam or full height wall, unless metal hangers are installed to provide proper bearing support against other structural components. Beams, which support the floor joists over greater spans, are constructed in the form of laminated joists often referred to as built up beams, or one piece solid load bearing beams, cut from logs or manufactured. Electricians and plumber may often cut or drill into the joist work to install utilities, and this is accepted, so long as they do not remove more material than what is required by codes. This type of floor system is usually the cheapest to install.
So let`s start off this article with talking about the number 1 reason our engineered oak floors have the upper hand over solid oak floors, this being it`s stability. A quality engineered board will be made up of around 10 layers of multi laminated birch ply wood. These layers are stuck in opposite directions with a moisture resistant adhesive and this gives the floor an immense amount of stability. We have been asked before by customers who have researched the market how strong the adhesive is as they have heard of stories of engineered wood flooring de-laminating.
Moisture is definitely a no-no when it comes to your hardwood floor. Even though you know that trees are grown from a major ingredient of water, you also know that water aids wood in changing its shape. Just for kicks, ask yourself this question: Would you wash down your intricately etched wood and antique finished dresser, curio or bedroom suit with any type of water solution? Your wooden floor needs that same type of care and attention in order to yield many years of comforting wood floor sheen, elegance and beauty.
For the second variable here is a controversial opinion: we do not end match our flooring which means there is no tongue and groove on the ends of the planks. Since we recommend our floor be glued down we say this is an unnecessary expense for the customer. End matching reduces the yield in production and raises labor costs. Most end match profiles are milled so loosely that they really don`t hold the floor in place anyway. The biggest benefit to the installer is that the plank can be cut in half in any place and reused anywhere without have to mate up to a complementary tongue or groove since the end is just square cut. This means all end trim pieces or any waste can be reused. Therefore on our engineered flooring product the waste factor is virtually nothing unless there are angles or radiuses to work around. We also help with waste factor by usually supplying a random width product so when one gets close to the end of a room they can plan the width combination patterns out to not have to rip much off the last row.