Nanine Flooring August 02nd, 2017 - 14:44:53
Here is a word on prefinished product if they factor into your decision. If you come up short on your order, the next lot that you buy may not match your previous batch. This is especially a problem on the lower end price floors and import floors. Good luck trying to blend it in with your previous floor. So if you go this route, be extra accurate on your measurements. Right now the rage is lifetime warranties on flooring. We stop to think is that really even possible? First will that importer or manufacturer really be around a lifetime? A lot of products are made oversees; the warranty is only good if there is somebody still around for the life of the warranty.
One drawback is that this type of floor requires special hanger systems designed for the joists, to enable them to be hung from each other or against beams/bearing walls. Manufactured joists are becoming a popular flooring system, for they are relatively cheap, reduce labour time and provide adequate support. However, builders need to familiarize themselves with its installations, for poor installation can cause severe structural damage to the joists. A good example is a three point, center bearing joist, left with the top chord uncut, which can potentially fail or pull apart, over the center bearing point.
We personally do not care for prefinished flooring due to installation problems associated with it, so our product requires site applied finish. This means that your floor finish if site applied will be easier to sand and refinish than a prefinished floor. Also you do not have to deal with that micro bevel groove between each board that tends to fill up with dust and crumbs. Most prefinished hardwood floors really can`t be refinished easily. To sand it off means that the wear layer has to be thicker than the height of the nails and have room to sand off the micro bevel between boards; that amounts to a lot of sanding. You also will not be able to spot sand or touch up parts of the floor.
As a reoccurring theme in this article you will find that you often get what you pay for. Admittedly, the higher end price point products ($11+/sf) from more rare woods are not necessarily better quality but we find that up to that point quality improves with price. Our solid wood floors range in price from $4-9 per square foot and our engineered ranges from $7-15 per square foot. We will discuss applications below, but our point is that you need to have a realistic budget when shopping. Sometimes a nice alternative if you have your heart set on an expensive floor is to use less of it and put it just in key areas. Don`t do the whole house. Maybe just do the main high traffic areas and use a cheaper alternative in bedrooms.