Nynette Flooring August 10th, 2017 - 18:26:52
So, a top quality oak engineered flooring will look the same but will it actually last as long?. How long a floor will last is mostly down to something called its `wear layer`. The part of the floor that is classed as the wear layer is from the surface of the board down to the tongue and on a solid oak board this would be around 5-6mm. Now, the wear layer on engineered wood flooring is the top layer of oak. So if you purchase an engineered oak flooring which has a 5-6mm solid oak top layer it will result in the flooring lasting just as long. In conclusion if you want an engineered flooring that is going to last as long as a traditional solid oak floor then make sure it has a nice thick top layer of wood, ideally 5mm+.
As a reoccurring theme in this article you will find that you often get what you pay for. Admittedly, the higher end price point products ($11+/sf) from more rare woods are not necessarily better quality but we find that up to that point quality improves with price. Our solid wood floors range in price from $4-9 per square foot and our engineered ranges from $7-15 per square foot. We will discuss applications below, but our point is that you need to have a realistic budget when shopping. Sometimes a nice alternative if you have your heart set on an expensive floor is to use less of it and put it just in key areas. Don`t do the whole house. Maybe just do the main high traffic areas and use a cheaper alternative in bedrooms.
Traditional tile installation requires many tools and lots of patience which have to be pre-set on the floor, cut down to size, then adhered to the floor using a strong industrial glue. They will not stick to every surface and frequently, a layer of floor base must be installed before the tiling work can begin. If the tiles are placed too close together, they can buckle, leaving unsightly bumps and lumps on the floor. If they are placed too far apart, there will be obvious gaps. If a mistake is made when laying down the tile, it is very difficult to fix as the tile is glued to the floor. The tile will have to be pried up, excess adhesive scraped, and the process started over. Laying traditional tile floors is a project that can take several days, to several weeks, to finish.
Strip floors, were once the most popular type of sub-floor installed. But with the introduction of manufactured sheathing products, it has become less utilized. Strip floors consist of 1" by 6" or 8" boards, placed diagonally over the floor joist framing system. It is slightly more expensive to install, and requires experienced tradesmen. To install such floors properly, the lumber should be non-kiln dried, with a relatively high moisture content. This may seem odd, but in reality, as the wood dries out, it will shrink.