Nynette Flooring August 15th, 2017 - 16:43:18
Here is a word on prefinished product if they factor into your decision. If you come up short on your order, the next lot that you buy may not match your previous batch. This is especially a problem on the lower end price floors and import floors. Good luck trying to blend it in with your previous floor. So if you go this route, be extra accurate on your measurements. Right now the rage is lifetime warranties on flooring. We stop to think is that really even possible? First will that importer or manufacturer really be around a lifetime? A lot of products are made oversees; the warranty is only good if there is somebody still around for the life of the warranty.
Traditional tile installation requires many tools and lots of patience which have to be pre-set on the floor, cut down to size, then adhered to the floor using a strong industrial glue. They will not stick to every surface and frequently, a layer of floor base must be installed before the tiling work can begin. If the tiles are placed too close together, they can buckle, leaving unsightly bumps and lumps on the floor. If they are placed too far apart, there will be obvious gaps. If a mistake is made when laying down the tile, it is very difficult to fix as the tile is glued to the floor. The tile will have to be pried up, excess adhesive scraped, and the process started over. Laying traditional tile floors is a project that can take several days, to several weeks, to finish.
For the second variable here is a controversial opinion: we do not end match our flooring which means there is no tongue and groove on the ends of the planks. Since we recommend our floor be glued down we say this is an unnecessary expense for the customer. End matching reduces the yield in production and raises labor costs. Most end match profiles are milled so loosely that they really don`t hold the floor in place anyway. The biggest benefit to the installer is that the plank can be cut in half in any place and reused anywhere without have to mate up to a complementary tongue or groove since the end is just square cut. This means all end trim pieces or any waste can be reused. Therefore on our engineered flooring product the waste factor is virtually nothing unless there are angles or radiuses to work around. We also help with waste factor by usually supplying a random width product so when one gets close to the end of a room they can plan the width combination patterns out to not have to rip much off the last row.
Truss floors are simply that. They are constructed from small dimensioned lumber, interconnected in a webwork pattern by the use of metal or wood plates. Occasionally, the trusses will be built on site, utilizing plywood plates to connect the webwork together. Generally they are installed 24" apart, either suspended on bearing walls or beams, or installed with plywood trim or rim joists around the perimeter. Strapping is installed on the bottom side, to prevent turning in place, which is a common ailment for deep truss components.