Published at Saturday, 21 October 2017 by Solaina in Garage Floor, with total 27 photographs.
Garage floor mats are economical, improve the look of the floor and are quick and easy to install. Costing less than $2 a square foot on average, they are the fastest of all three options to put down. They can be purchased online, as a roll or a complete mat, and installation is as simple as cutting them to fit the garage as needed, and then unrolling. They create a seamless look in a smaller garage or can be used only under the car in a larger garage. Manufactured with raised patterns to reduce slipping, they are not a good solution for use on unsealed cement floors, as the ground moisture seeping upwards through the pores of the concrete will be trapped under the non-porous polyvinyl of the mat, causing mold and bacteria to flourish and eroding the floor over time.
In each of the examples above it is important to know the width and length of your garage. Many of the garage floors available come in various patterns and are generally rolled out from the back of the garage to the front. By doing this, the seem will run along the length of the garage. To determine the width of the rolls you will need you simply take the width of your garage and divide it by the various widths of flooring available. The most common widths of rolled garage flooring are 7.5, 8, 9 and 10. If your garage is 22 wide then the best choice would be 3 rolls of the 7.5 width flooring. That would give you the least amount of waste when you install your floor. Three rolls at 7.5 wide would cover an area 22.5 wide providing only 6 inches of waste.
When it comes to garage flooring, many of you may have heard or seen the epoxy floor coverings that are available today, possibly even on TV. You see what looks like a simple process and beautiful results. What you dont see or hear is that most epoxy floor coverings fail and the process is extremely time consuming and difficult. The biggest reason the epoxy garage floors fail is adhesion, they simply dont stick well unless the surface has been properly prepped. That doesnt sound bad, right? Wrong. Here are some of the things you need to do to "prep" for an epoxy floor: